7.1 Option Card InstallationThis section provides instructions on installing option cards.u Installing Option CardsTable 7.1 below lists the number of option cards that can be connected to the drive and the drive ports for connecting thoseoption cards.Table 7.1 Option Card InstallationOption Card Port/Connector Number of Cards PossibleSI-EN3, SI-EM3, SI-N3, SI-P3, SI-T3, SI-C3, SI-S3,AI-A3 <1> , DI-A3 <1> CN5-A 1PG-X3, PG-B3 CN5-B, C 2 <2>DO-A3, AO-A3 CN5-A, B, C 1<1> Option cards AI-A3 and DI-A3 cannot set the frequency reference when installed to ports CN5-B or CN5-C. It is still possible, however, to viewthe input status using U1-21, U1-22, U1-23 (for AI-A3), and U1-17 (for DI-A3).<2> Use port CN5-C when connecting one PG option card. Use ports CN5-B and CN5-C when connecting two PG option cards.u Installation ProcedureWARNING! Electrical Shock Hazard. Do not allow unqualified personnel to perform work on the drive. Failure to comply could result in deathor serious injury. Maintenance, inspection, and replacement of parts must be performed only by authorized personnel familiar withinstallation, adjustment and maintenance of AC drives and Option Cards.NOTICE: Damage to Equipment. Observe proper electrostatic discharge procedures (ESD) when handling the option card, drive, and circuitboards. Failure to comply may result in ESD damage to circuitry.NOTICE: Damage to Equipment. Tighten all terminal screws to the specified tightening torque. Failure to comply may cause the applicationto operate incorrectly or damage the drive.Use the procedure described below when installing option cards to the drive.1. Shut off power to the drive, wait the appropriate amount of time for voltage to dissipate, then remove the operator andfront cover. Refer to Digital Operator and Front Cover on page 46.2. Insert the CN5 connector on the option card into the matching CN5 connector on the drive, then fasten it into placeusing one of the screws included with the option card.ABCDEF GJKLIHA – Connector CN5-CB – Connector CN5-BC – Connector CN5-AD – Drive grounding terminal (FE)E – Insert connector CN5 hereF – Option cardG – Mounting screwH – Ground wireI – Use wire cutters to create anopening for cable linesJ – Front coverK – Digital operatorL – Terminal coverFigure 7.1 Installing an Option Card3. Connect the ground wire to the ground terminal using one of the screws.7.1 Option Card Installation158 YASKAWA ELECTRIC TOEP C710616 41B YASKAWA AC Drive - A1000 Quick Start Guide
