u CIMR-Ao2A0110 to 2A0415, 4A0058 to 4A1200 (IP00 Enclosure)n Removing the Terminal Cover1. Loosen the screws on the terminal cover, then pull down on the cover.Note: Drive models CIMR-Ao2A0250 to 2A0415 and CIMR-Ao4A0208 to 4A1200 have three screws on the top of the terminal cover.CAUTION! Do not completely remove the cover screws, just loosen them. If the cover screws are removed completely, the terminalcover may fall off causing an injury.Figure 3.11 Removing the Terminal Cover on an IP00 Enclosure Drive2. Pull forward on the terminal cover to free it from the drive.Figure 3.12 Removing the Terminal Cover on an IP00 Enclosure Driven Reattaching the Terminal CoverAfter wiring the terminal board and other devices, double-check connections and reattach the terminal cover. Refer to Wiringthe Main Circuit Terminal on page 59 and Wiring the Control Circuit Terminal on page 64 for details on wiring.<1>Figure 3.13 Reattaching the Terminal Cover on an IP00 Enclosure Drive<1> Connect the ground wiring first, then the main circuit wiring, and finally the control circuit wiring.3.3 Terminal CoverYASKAWA ELECTRIC TOEP C710616 41B YASKAWA AC Drive - A1000 Quick Start Guide 453 Electrical Installation