5.3 Key Operations and Display5 -75.3.3 Operation Status Display ModeTo check data in operation status display mode, do as follows. The following shows the example whereU1-09 (sequence input signal status) is to be changed.Description KeySequence Digital Operator Display RemarksS U1-01 is displayed.S Move blinking cursor to thedata No. RESETDepress [>] key once more to returnthe blinking cursor.S Select U1-09.S Display U1-09 data con-tents.DATAENTERThe display example is the statuswhen [RDY] and [EMG] signals areON.S Return to operation statusNo. display DSPLFor explanations of operation status display, refer to Chapter 11 Operating Status Displays.5.3.4 Control Constant Display ModeTo check data or set/change a constant in control constant display mode, do as follow. The following showsthe example where C1-10 (soft-start time) is to be changed.Description KeySequence Digital Operator Display RemarksS C1-01 is displayed.S Move blinking cursor to thedata No. RESETDepress [>] key once more to returnthe blinking cursor.S Select C1-10.S Display C1-10 data con-tents.DATAENTER S Select data line to bechanged. RESET S Change set value. (1→5)S Write-in set value. DATAENTERDisplayed for 0.5 sec.*S Press DATA/ENTER Keyuntil “End” is displayed. Returns to previous display beforewrite-in.S Return to control constantNo. display. DSPLNote: When data outside the input range are set, “End” will not appear on the display and all data lineswill continue blinking even when the [DATA/ENTER] is held down. To correct this condition,depress [DSPL] key returning to the data number display and correct the settings.Refer to Chapter 10 Control Constants for contents of control constants.5
