5.1 Function of the Digital Operator5 -3Fig. 5.1 shows the display section and operation keys of the Digital Operator, and Fig. 5.2 shows the LED dis-play status of the RUN and STOP keys. Table 5.1 shows the displayed characters and the corresponding alpha-bets and numbers, and Fig. 5.3 shows the display of bit selection signal.LOCALREMOTEDigital OperatorJVOP-132DSPLDATAENTERJOGFWDREV RESETRUN STOPDRIVE FWD REV REMOTE REFSEQDRIVEPRGMMode Display LEDDisplayDisplay Selection KeyJOGDRIVE FWD REV REMOTEREFSEQDigital Operator Running IndicationLights in the Digital Operator operation mode.Rotation Direction IndicationFWD: Lights when forward run command isinput.REV: Lights when reverse run command isinput.Remote Mode IndicationSEQ: Lights when the motor rotates in the re-verse direction.Displays monitored values of speed referenceand function set values.Depress this key to select display items.Read/Write KeyDepress this key to display set values ofconstants. Depress this key again to writeset values.Numeral Change KeyUse these keys to change values such as setvalues and constant Nos.∧: Increment key∨: Decrement keyDigit Selection KeyUse this key to select a position in a set val-ue to be changed. The selected positionblinks. (Use this key to reset after and erroroccurs.)Run Command KeyThese are run command keys when the drive is oper-ated by the Digital Operator. These keys are effectiveonly in operation by Digital Operator.STOP: Stop commandWhen STOP is depressed, the red LED onthe left part of the key lights.RUN: Run commandWhen RUN is depressed, the red LED onthe left part of the key lights.FWD/REV: Forward and reverse rotation switchWhen this key is depressed, directionof rotation is changed.JOG: Jog run:When this key is held down, joggingis possible.DRIVE/PRGM: Emergency stopWhen this key is depressed, the op-eration speed is reduced and stopped.Then current is interrupted.REF: — — —Fig 5.1 Display Unit and Operation Keys of the Digital OperatorRUN and STOP LEDs light, blink, and go OFF depending on the status of operation.JOGFWDREV RESETRUN STOPMotor SpeedON Blink OFFSpeed ReferenceLEDRUNLEDSTOP[FWD]or [REV]Main Circuit Power SupplyFig 5.2 LED Display of RUN and STOP Keys5
