Notes for MotorviiNotes for MotorJ Notes on UseWARNINGObserve the following precautions to avoid electrical shock or injury.D Ground the ground terminals of the Inverter and the Motor (or ground a metallic part, such as theframe, if there is no ground terminal, according to local and/or national electrical codes.Failure to observe this warning may result in electrical shock.D Use grounding wires of a size complying with relevant international or local standards.D Make wiring lengths as short as possible. Separate power cables from signal lines.Noise on signal lines may cause vibration or malfunctions.D Perform wiring or inspection only after verifying that the CHARGE indicator and the 7-segmentdisplay of the Inverter go OFF after the power supply is turned OFF.Failure to observe this warning may result in electrical shock.D Do not damage the cables or apply excess stress to them; do not place heavy objects on thecables or clamp the cables.Failure to observe this warning may result in electrical shock.CAUTIOND Use only a specified combination of Inverter and Motor.Failure to observe this caution may result in fire or malfunctions.D Never use at locations exposed to water splashes, corrosive, or inflammable gases, or nearcombustible substances.Failure to observe this caution may result in fire or malfunctions.D Use under the following environmental conditions.(1) Indoors where no corrosive or explosive gas exists(2) Well-ventilated without dust or metallic particles(3) Easy to check, clean, and maintainFor use at locations where excessive water or oil splashes exist, use a cover or other protection.It is recommended to place the terminal box upward.D Do not touch the Motor while the power is ON or immediately after turning the power OFF.Failure to observe this caution may cause harmful burn.J StoragePROHIBITEDD Do not store the equipment in locations where water splashes are present or where there arecorrosive gases or liquids.MANDATORYD Store the equipment protected from direct sunlight in the specified ranges of temperature andhumidity. (0°C to 60°C (32°F to 140°F), 5% to 95%)D After long-term storage, contact your YASKAWA representative before using the Motor.
