STARTUPAxio Scope.A1 Mounting the Standard Components Carl ZeissM60-2-0007 e 05/08 393.1.9 Mechanical Stages with Friction AdjustmentDrive length and friction for the X- and Y-adjustment can be adjusted individually on the standardmechanical stage (432035-9000-000) and the mechanical stage 432035-9070-000.(1) Adjusting the drive length on the stagedriveThe drive length of the X- and Y-drive can beadjusted by an axial shift of the gear knob(3 6 0 H 3 6 0 H Fig. 3-14/4 and 1) within a range of approx.15 mm.(2) Adjusting the frictional momentum of thegear knobs for the X-/Y-adjustment of themechanical stageThe friction momentum of the gear knobs isfactory-adjusted to a mid degree which can bechanged as follows if necessary:a) X-drive• Slide the gear knob for the X-adjustment (3 6 1 H 3 6 1 H Fig.3-14/4) all the way down.• Take the enclosed adjustment pin (362H362HFig. 3-14/5)out of the gear knob for the Y-adjustment (363H363HFig.3-14/1) and stick it into one of the holes on thelower hole nut (364H364HFig. 3-14/3).• Hold the gear knob for the X- adjustment (365H365HFig. 3-14/4) and turn the hole nut with the adjustment pinclockwise (smaller friction momentum: –) or counter clockwise (larger friction momentum: +) until youreach the desired friction degree (see 3 6 6 H 3 6 6 H Fig. 3-14).• The adjustment should not be more than one rotation.b) Y-drive• Slide the gear knob for the Y-adjustment (367H367HFig. 3-14/1) all the way up.• Stick the enclosed adjustment pin (3 6 8 H 3 6 8 H Fig. 3-14/5) into the hole on the upper hole nut (369H369HFig. 3-14/2).• Hold the gear knob for the Y-adjustment (370H370HFig. 3-14/1) and turn the hole nut with the adjustment pinclockwise (smaller friction momentum: –) or counter clockwise (larger friction momentum: +) until youreach the desired friction degree.• The adjustment should not be more than one rotation.• Replace the adjustment pin in the gear knob for the Y-adjustment (3 7 1 H 3 7 1 H Fig. 3-14/1).Fig. 3-14 Adjusting the frictional momentum