STARTUPAxio Scope.A1 Mounting Optional Components Carl ZeissM60-2-0007 e 05/08 61The reflecting (coated) side (550H550HFig. 3-46/3)of the color splitter has a tapered edge(5 5 1 H 5 5 1 H Fig. 3-46/1) or corner (5 5 2 H 5 5 2 H Fig. 3-46/2).• Put the excitation part of the module(5 5 3 H 5 5 3 H Fig. 3-45/1) on the emission part (5 5 4 H 5 5 4 H Fig. 3-45/4)– holding fixtures (555H555HFig. 3-45/5b) and eyelets(5 5 6 H 5 5 6 H Fig. 3-45/5a) latch together. Hold both partstogether and turn them back into mountingposition.• Replace the slit screws and tighten them.• Last, stick the sticker with the name of the filtercombination on the side of the module.3.4.7 Mounting the Polarizer D or theFilter Holder• For an easy assembly, remove the condensercarrier (557H557HFig. 3-47/3) fully, with the stage carrier.• If necessary, unscrew stop bolt and bracket boltwith overview fixture from the condensercarrier.• Hold the polarizer or filter holder (558H558HFig. 3-47/6)parallel to the bottom of the condenser carrier(5 5 9 H 5 5 9 H Fig. 3-47/3) and screw the bracket bolt(5 6 0 H 5 6 0 H Fig. 3-47/4) of the polarizer (561H561HFig. 3-47/6) withthe angled adjustment lever (5 6 2 H 5 6 2 H Fig. 3-47/5) in tothe front threaded opening at the left belowthe condenser carrier (563H563HFig. 3-47/3) until it stops.• Screw the stop bolt (5 6 4 H 5 6 4 H Fig. 3-47/2) with theadjustment lever (5 6 5 H 5 6 5 H Fig. 3-47/1) to the stop intothe back threaded opening of the condensercarrier (566H566HFig. 3-47/3).Proceed analogically when mounting the other components listed in the Systems Overview.Fig. 3-46 Labeling the color splitterFig. 3-47 Mounting the polarizer D