STARTUPCarl Zeiss Mounting the Standard Components Axio Scope.A146 M60-2-0007 e 05/083.1.15 Halogen Lamp HAL 100The halogen lamp HAL 100 may serve as light source for transmitted light and reflected light procedures(except fluorescence light) as long as either the lower stand part or the upper stand part are equippedwith the appropriate connection piece. When mounting the halogen lamp, no difference is madebetween reflected light and transmitted light procedures.3.1.15.1 Mounting the halogen lampHAL 100Before you switch on the halogenlamp, please be sure to remove thetools which are included in the lampcase. The lamp generates a lot of heatwhich could damage these tools (seechapter 4 1 7 H 4 1 7 H 3.1.15.3).• Remove the cap from the reflected light ortransmitted light connector.• Insert the lamp case (418H418HFig. 3-23/8) with thedovetail ring into the connector (419H419HFig. 3-23/2 and420H420HFig. 3-23/3). Now fixate it by tightening theclamping screw (4 2 1 H 4 2 1 H Fig. 3-23/1 or 4 2 2 H 4 2 2 H Fig. 3-23/9) withthe ball head screwdriver SW 3.Due to the lack of ground clearance itis important to avoid canting the lampwhen inserting it into the lower standpart. Check for straight and correct fit.• Insert the 3-pin lamp plug (423H423HFig. 3-23/7) into theback of the external power supply (4 2 4 H 4 2 4 H Fig. 3-23/6).When mounting HAL 100 to the lower stand part for HAL 100 illumination, it is necessary touse an additional control cord (425H425HFig. 3-23/5) for the light intensity (see chapter 4 2 6 H 4 2 6 H 3.2.2). The lightintensity of HAL 100 can then be adjusted with the control wheel (427H427HFig. 3-23/4).The light intensity of HAL 100 can also be adjusted with the external power supply unit. In thiscase, the control cord needs to be removed.Fig. 3-23 Mounting the halogen lampHAL 100
