B-2 APPENDIX B: CLI COMMAND DESCRIPTIONYou must use add user to create a network type user for this command, and setuser to specify the protocol and other parameters related to bridging.add dns host addressAdds the named host to the Local Host Table. When the system needs to resolvean address for an IP host name, the Local Host table is checked first, before arequest is sent to the remote DNS Name Server.The add login_host command may also add to this table. See that command’sdescription for details.add dns server primary_address [ip_address] secondary_address [ip_address] vc_name [vc_name]Adds the IP address of a remote DNS Server for the specified Domain Name to theDomain Name Server Table. The first specified server is sent the IP host name to beresolved, first without, and then with the default domain name (see set dns formore information about the default domain name). If that server cannot resolvethe name, it is sent to the next specified server. If PPP is being used for a wide areaconnection, the vc_name parameter to specify a remote connection from whichthe primary and secondary addresses will be learned.add filterAdds a filter file name to the filter table. The filter table is a managed list of filternames used by SNMP. A filter file is a text file stored in the FLASH file system, thatyou load using TFTP. Add filter also verifies the syntax of the filter file.If syntax verification fails, you’ll receive an error message, and the filter will still beadded to the table, but is not usable.Parameter Description Designation you wish to give to this bridge network.enabled Default is to enable the bridge network.Parameter Description Designation of the local host. IP address of a named host in nnn.nnn.nnn.nnn format.Parameter Description Domain name. Use * for all domains.Status The status concerning the DNS server.primary_address The primary IP address of the DNS server.secondary_address The secondary IP address of the DNS server.vc_name The VC profile to use for obtaining the DNS addresses
