B-50 APPENDIX B: CLI COMMAND DESCRIPTIONshow ipx sap settings countersDisplays information about SAP for IPX.show ipx settings Displays settings for dynamic IPX networks. You can modify these values using theset ipx system command. Default Gateway - default IPX router address Max Open Sockets - maximum allowed number of open sockets toremote IPX networks Max Hops - maximum allowed hops to remote IPX networks. Priority - preferred ranking of dynamic IPX networks Dynamic Address Pool Begin - starting IPX address Dynamic Address Pool Size - number of addresses to reserve for dynamicIPX address assignmentsshow memory Displays System DRAM Memory usage. Total System Memory Resources - total amount of memory in system Free Memory - amount of memory not in use Code Size - amount of memory used by code Initialized Data Size, Uninitialized Data Size, Stack Size - static dataareasshow network settingsDisplays the configured settings for the specified network. The display variesdepending on the type of network specified. Some of the settings displayed areInterfaces, Network Address, Frame Type, Status, User Name, and Spawning TreeEnabled.show network countersDisplays the statistical counters for the specified network. The display variesdepending on the type of network specified. Some of the counters are ReceivedFrames, Transmitted Frames, and Discarded Frames.Parameter Descriptionsettings Displays the state of the IPX routing. This is ON or OFF.counters Displays the Incorrect RIP Packets for the IPX routing. The incorrect RIPpackets are the number of RIP packets that do not make sense.Parameter Descriptionsettings Displays the state of the IPX routing. This is ON or OFF.counters Displays the Incorrect SAP Packets for the IPX routing. The incorrect SAPpackets are the number of SAP packets that do not make sense.
