CLI Commands B-49 RIP In Packets - sum of RIP packets received SAP Out Packets - sum of SAP packets transmitted SAP In Packets - sum of SAP packets receivedshow ipx networksettingsDisplays parameter settings for the specified IPX network. You can modify most ofthese values using the set ipx network command. Interface - interface this IPX network uses Network Address - network address of this IPX network Frame Type - frame type used by the interface (ETHERNET II, SNAP, orLOOPBACK) Maximum Packet Size - maximum allowable packet size for this IPXnetwork. Default is 1500. Status - operational state of the network Network Delay (ticks) - time in number of ticks it takes to reach this IPXnetwork Network Learning Retries - number of times this network will re-sendpackets to discover its directly connected neighbors Diagnostics - sending of diagnostic packets ENABLED or DISABLED NetBIOS - support ENABLED or DISABLED NetBIOS Name Caching - support ENABLED or DISABLED NetBIOS Cache Timer (sec) - interval a NetBIOS system will be kept in thecache NetBIOS Maximum Hops - most hops this network will make to locate aNetBIOS system RIP - RIP status RIP Update (sec) - number of seconds to wait before aging out RIP entries RIP Age Multiplier - number to multiply the rip_update_interval by, toobtain the value for aging out the entries in the RIP database RIP Max Packet Size - largest allowable size of a RIP packet SAP - SAP state SAP Update (sec) - number of seconds to wait before aging out SAPentries SAP Age Multiplier - number to multiply the sap_update_interval by, toobtain the value for the aging out entries in the SAP database SAP Packet Size - greatest allowable size of a SAP packet SAP Nearest Server Reply - SAP seeks nearest neighbors, YES or NOshow ipx rip settings countersDisplays information about RIP for IPX.
