B-38 APPENDIX B: CLI COMMAND DESCRIPTIONset vc atm set [number] category_of_service [Unspecified (UBR) | Variable (VBR)] pcr [number] scr [number] type [PVC | SVC] vci [number] vpi [number]management_ip_addressSecondary IP address on the VC for Management purposes only. If theManagement IP address is configured, the ‘local_IP_address’ must beconfigured as numbered.Address is configured with the following format:xx.xx.xx.xx/nn -- where nn is the number of bits in the netmask ornetmask class (i.e., A, B, or C).MTU Maximum Transfer Unit - largest data packet size allowed.NAT_option Enable or disable PAT, NAT, or Super NAT.PAT_default_addressDefault workstation address that incoming IP traffic will get forwarded toif the demuxing of the network address translation is unresolved.Network_service Type of network service. Default is PPP.output_filter Name of filter file in FLASH memory to be applied to output data stream.Password The password is an alphanumeric string of maximum size 15 characters.remote_IP_address For a client IP connection, address assigned to the client.Rip Selects either RIPV1 or RIPV2 for IP RIP.rip_authentication Text string used for RIPv2 authentication.rip_policies_updateAllows VC to enable or disable RIP policies. See text on the precedingpage for description of keywords. A keyword with a NO_ in front is usedto disable the policy. Default is indicated by (D).SEND_DEFAULT/NO_SEND_DEFAULT(D)SEND_ROUTES(D)/NO_SEND_ROUTESSEND_SUBNETS/NO_SEND_SUBNETS(D)ACCEPT_DEFAULT/NO_ACCEPT_DEFAULT(D)SPLIT_HORIZON(D)/NO_SPLIT_HORIZONPOISON_REVERSE(D)/NO_POISON_REVERSEFLASH_UPDATE(D)/NO_FLASH_UPDATESEND_COMPAT(D)/NO_SEND_COMPATRIPV1_RECEIVE(D)/NO_RIPV1_RECEIVERIPV2_RECEIVE(D)/NO_RIPV2_RECEIVESILENT (default is disabled)send_name An identification name sent to the remote network.send_password Password sent to the remote network. Limit: 15 characters.Type Describes type of connection. Options:ONDEMAND - makes connection when the system needs a session withthe remote network.CONTINUOUS - keeps connection up all the timeMANUAL - manually starts connection using the CLI
