CLI Commands B-27set facilityloglevel [level]Sets the severity reporting level for a facility. The hosts that will receive the errorlog entries are defined using add syslog loglevel. Use list facilities to see what thecurrent loglevel is for each facility. The levels: CRITICAL - a serious system error, which may effect system integrity UNUSUAL - an abnormal event, which the system should recover from COMMON - a regularly occurring event that is not frequent VERBOSE - a regular periodic event, e.g. a routing update message DEBUG - for debugging purposes onlyset ilmi vpi vci This allows modification of the Virtual Path or Channel ID that will be used forexchanging ILMI (Integrated Local Management Interface) messages.set interface filter_access [ON | OFF] input_filter output_filter Sets filter parameters for the specified protocol on the specified interface. You cansee the available filter files using list filters, view the contents of a filter file usingshow filter, and add filter files to FLASH memory using TFTP.set ip network broadcast_algorithm [number] reassembly_maximum_size [number] rip_authentication [string] rip_policies_update routing_protocol [NONE | RIPV1 | RIPV2]timeout Number of seconds to wait before deciding a request to a Name Server hastimed out. Minimum interval and default is 5 seconds, maximum interval is120 seconds.Parameter Descriptionvpi The virtual path identifier for the ILMI.vci The virtual channel identifier for the ILMI.Parameter Description Designation of interface you are setting parameters for. Limit of 32characters.filter_access ON causes filters specified for an interface with a set interface command,to override filters specified with a set user command, when the filters areof the same type.input_filter Name of filter file you wish to be applied to the input stream coming in onthe specified interface. Limit: 20 characters.output_filter Name of the filter file you wish to be applied to the output stream leavingthe specified interface. Limit: 20 characters.
