CLI Commands B-23PINGping output [output_filename] count [count] interval [interval] timeout [timeout_value]Sends an ICMP echo request to a remote IP host. A reply from the pinged addressindicates success.QUICKVC Runs the QuickVC Setup program to easily configure a virtual channel connection(remote site profile). See Chapter 5 for a complete description of the QuickVCSetup program.REBOOT Reboot the system. If you have made any configuration changes, be sure to saveall before rebooting. Also see the delete configuration command.RENAMErename fileRenames files within the FLASH file system.The FLASH file system is a flat file system (no subdirectories). Use the list filescommand to see what files currently exist.RESOLVEresolve nameReturns an IP Address for the specified host name by sending it to DNS forresolution. If the Domain Name has been specified using the set DNS command, itwill also be resolved, otherwise you must specify it as part of the name. Thiscommand requires either a DNS local host entry (use add DNS host) or a DNSserver (use add DNS server) to resolve the host name. It is the reverse of the ARPcommand.More (or CR) Continue printingParameter Description IP address in dotted notation, or host name of remote system.output A file name to direct output to.count Number of ICMP echo requests to send.interval Number of seconds to wait between sending each request.timeout Number of seconds to wait for an echo response to return.Parameter Description Name of the original file. New name for the file
