B-20 APPENDIX B: CLI COMMAND DESCRIPTION Prot - LOCAL or RIP NextHop - address of the gateway used to reach this route Metric - number of router hops away this route is from the system If - interface that the route useslist ipx networks Displays the IPX networks that you previously defined using the add ipx networkcommand. It lists: Name - designation you assigned this network Prot - protocol; always IPX Int - interface each IPX network runs on State - ENABLED or DISABLED Type - STATIC or DYNAMIC Network Address - network address of this IPX networklist ipx routes Displays the IPX routes that you previously defined using the add ipx routecommand, plus the defined IPX nodes. It lists: Network Addr - network address of this route Prot - protocol used to find this route: LOCAL, RIP, STATIC, NLSP, OTHER NextHopNIC - network address of the next router (the next hop to thedestination), or the MAC address for the local IPX nodes (on the LAN) Gateway - address of the gateway to this network Metric Ticks - number of hops through routers this network is distant fromlist ipx services Displays IPX services. It lists: Name - name of the IPX service NetNum - network number that the service is on Node - name of the IPX node running the service Socket Type - socket number of the service Prot - protocol used to find this service: SAP, LOCAL, NLSP, STATIC orOTHER Metric - number of hops through routers to reach this servicelist lan interfaces Displays the operational and administrative status (UP or DOWN), interface indexnumber and name (eth:1) of all LAN interfaces. The output is the same as the listinterfaces command, except only LAN interfaces are displayed.list networks Displays all defined networks running any protocol. The command lists: Name - designation of the network that you defined with add network Prot - protocol of the network (IP or Bridging) Int - interface the network is running on State - ENABLED or DISABLED network
