Configuring SNA 9-15Subscriber Parameters1 The software does not verify that the specified port exists. Make sure the specified portsare configured in the database, and that they actually exist.Subscriber Nameidentifies the subscriber to the console operator.Routing Algorithmallows creation of a "hunt group" of ports (see example on page 8-22), for the purposeof routing per a pre-selected algorithm:0 = Round Robin – selects ports specified cyclicly in numerical order accordingto the list of Redirection Addresses. If the selected port is unreachable or con-gested, the Call Request will be sent to the next port. (If the port becomesavailable again, it will be included in its assigned position.)1 = Alternate Route on Line Failure – selects the first port that is not in a failedstate. If the selected port does not make a connection, the call will be cleared, evenif other ports are available.2 = Alternate Route on Line Busy – selects the first port that has LCNs available(is not busy). If the port has failed, the next available port will be selected.3 = Least LCN with Throughput – selects the line with the minumum loading, cal-culated by weight and number of LCNs in use on that line. (Each line is assigneda weight proportional to its throughput within the routing path.)If use of a routing algorithm is not desired, simply accept the default, and specify onlyone routing path.See "Configuring a Hunt Group for SNA Subscribers."Table 9-3 SVC Subscriber ParametersParameter Valid Values Default ValueSubscriber Name 0–31 characters noneRouting Algorithm 0–3 0Systematic Redirection Y/N NRedirect on Busy Y/N NRedirect on Out of Order Y/N NConnection Priority 0–9 01st, 2nd,etc. Path Configured Y/N NRLP n/a 0Port Physical port: 0–3 1Logical port: 8-63 1 0Redirection Address 0,1,etc. valid address none
