19-10 SmartSwitch 1800 4.0 User Guide, Rev 01Local File RestoreThis operation applies only to a SmartSwitch 1800 with a PC attached tothe Console port. The PC must be running Procomm Plus with ZMODEM.The procedure was tested using Procomm Plus 2.1 for Windows, but otherversions containing ZMODEM should also work. It is assumed that anyoneperforming this procedure knows how to use ZMODEM.This operation places a heavy load on the SmartSwitch 1800'scentral processor, and should be performed only when there isminimal traffic on the node.This operation copies files from the locally attached PC to the SmartSwitch. The pro-cedure can be used to install a software update into the SmartSwitch, or to restoredatabase files that were backed up with the Local File Backup operation. The operationtransfers one file at a time, and you must know the name(s) of the file(s) you want totransfer. All possible database files are listed under "Local File Backup" earlier, and theoperating software files are listed below:APAD.CMP BRIDGE.CMP BSCI.CMP BSCB.CMPE1.CMP EAGLECAF.OUT FRAME_RE.CMP GATED.CMPIP.CMP IPX.CMP LLC2.CMP NETVSRVP.CMPPL.CMP SDLC.CMP SNMPD.CMP TRAPD.CMPV1DIAG.BIN V4K8.BIN V8K.BIN VB.CMPVBOOT.BIN VOICE.CMP VXWORKS.CMP VXWORKS.SYMTo copy one or more files to the SmartSwitch:1. In Procomm, use Setup if necessary to specify an Upload Path, which identifiesthe directory (in the PC) containing the file(s) to be copied to the SmartSwitch1800.2. Press [E] at the SmartSwitch 1800’s On-Line Node Operations Menu (or [B], [A],[E] from the Main Menu).3. Enter the letter corresponding to the desired operation when asked:Are you:A Installing a Software FileB Restoring a Database FileThis will ensure that the file(s) will be copied to the right place in the Smart-Switch 1800.4. Press [F] at the SmartSwitch 1800’s On-Line Node Operations Menu (or [B], [A],[F] from the Main Menu).5. After reading the warning, press [Enter].6. Click on the Procomm Send File icon. This will display a list of files in the UploadPath directory.7. Click on the file you want to copy to the SmartSwitch 1800, then click on OK.8. After the file has been copied to the SmartSwitch 1800, the On-Line Node Oper-ations Menu will be displayed. If you want to copy another file, press [F]; oth-erwise, make another selection or press [F3] to exit the menu.
