18-4 SmartSwitch 1800 4.0 User Guide, Rev 01F Protocol StatusA IPX RIP Table Display – displays the contents of the RIP table.B IPX SAP Table Display – displays the contents of the SAP table.C SDLC PU Status – displays a list of configured station addresses for aspecified SNA port, including current active/inactive states.D Bridge Status DisplaysA Bridge Port Status Display – displays a list of Bridge ports, includingtype, active status, bridge state (forwarding, listening, etc.), and numberof bytes received and transmitted.B Bridge Forwarding Table Display – displays a list of MAC addresses andtheir associated bridge ports, plus any flags that have been set.E Frame Relay Backup Status – displays the current state of frame relayprimary and backup DLCIs.A Display States for all Backup DLCIs on a PortB Display States for all Primary DLCIs on a PortC Display States for all Backup DLCIs in a GroupF LLC/2 Session Status – displays addresses and operational states of allcurrent LLC2 sessions.G IP Status DisplaysA IP Routing Table Display – displays interfaces, destinations, networkmasks, and flags.B IP ARP Table Display – displays ARP IP addresses, MAC addresses, andaging timers.C IP Interfaces Display – displays interface names, MTU values, networknames, masks, IP and remote addresses, and flags.H Voice IInterfaces Display – displays configured Voice interfaces.D Events – (Chapter 22) Displays event (alarm) messages as they occur.E Statistics (Chapter 21)A Configure RLP / Port Thresholds – allows creation of a threshold for a statisticthat, when crossed, will cause an alarm to be generated.B Display RLP / Port / Frame Statistics – displays the supported statistics for thespecified component, showing current values, as well as the highest valuesreached by each statistic since the node was last booted or since maximumvalues were last cleared.C Display IP Statistics – displays the supported statistics, including current valuesand cumulative values since maximum values were last cleared.D Display ICMP Statistics – displays the supported statistics, including currentvalues and cumulative values since maximum values were last cleared.E Display IP Interface Statistics – displays the supported statistics, includingcurrent values and cumulative values since maximum values were lastcleared.F Display IPX Interface Statistics – displays the supported statistics, includingcurrent values and cumulative values since maximum values were lastcleared.G Display LAN Card Interface Statistics – displays the supported statistics,including current values and cumulative values since maximum valueswere last cleared.H Display Frame Relay Utilization Statistics – displays CIR, BE , and BC values fora specified DLCI, as well as the configured and actual percentages ofbandwidth use by each bandwidth allocation group.I Display Voice StatisticsA Display Voice Application Statistics – displays data on calls received,transmitted, cleared, and accepted, as well as busy and time-out statistics.
