4-4 SmartSwitch 1800 4.0 User Guide, Rev 01Make sure that each Cabletron frame relay access device on thesame network is assigned a different Remote Control ID.Remote Control Pwdis a password used in conjunction with the Remote Control ID, and will be checkedagainst the user data field of a Call Request packet. Both the Remote Control ID andthe password must match what is expected, or the SmartSwitch will not accept arequest for remote control.File Transfer IDis used for file transfers (see page 19-4) to or from this SmartSwitch. The ID will bechecked against the called address field of a Call Request packets coming into thisSmartSwitch.File Transfer Pwdis a password used in conjunction with the File Transfer ID. Both the File Transfer IDand the File Transfer Pwd must match what is expected, or the SmartSwitch will notaccept a request for file transfer.Collecting Node IDis defined on a collecting node (described later) for use by other Cabletron frame relayaccess devices that send their alarms to that collecting node. This same ID must beconfigured on each non-collecting node as the Primary Alarm Output ID. The CollectingNode ID has no function on non-collecting nodes.Collecting Node Pwdis a password that will be checked to verify that the Primary Alarm Output ID is beingused for alarms. Since the same ID can be specified for several functions, the softwareprocesses can use the passwords to identify the different functions.Any non-alarm passwords must be different than any alarmpasswords. Unless you are certain you are not duplicating apassword, leave all passwords at the default settings.Primary Alarm Output IDspecifies where alarms will be sent. On a device configured as a collecting node, theID is usually associated with an async PAD port connected to a printer (or server). Onnon-collecting nodes, the ID is usually the Primary Alarm Output ID of a collectingnode. The alarm system is designed for guaranteed delivery to the primary outputdevice, and output to the secondary device only if it is available. Problems with thesecondary device will not stop delivery to the primary device.If specifying an async port to a printer, be sure to configure the Async PADProfile (see page 12-2) to match the line speed of the printer. (Do not con-figure the port for Autobaud.)Primary Alarm Output Pwdis a password that will be used with the Primary Alarm Output ID. If that ID is a col-lecting node, the local SmartSwitch's Primary Alarm Output Pwd (Password) mustmatch the collecting node’s Collecting Node Pwd.
