9-18 SmartSwitch 1800 4.0 User Guide, Rev 01Figure 9-5 LLC2 Defaults Configuration Screen[A],[A],[E],[B] from Main MenuOnly item A applies to LLC2. Leave the remaining parameters at theirdefault values.Configuring LLC2 HostsEach SNA/LLC2 host device that will connect to a SmartSwitch 1800 running LLC2must be configured in the database.To display any LLC2 hosts already configured for this node, press [C] at the ConfigureIP/LLC2/BRIDGE/IPX Default Parameters Menu (or [A], [A], [E], [C] from the MainMenu). This will list the hosts' MAC addresses and identify each LLC2 session asOriginated or Terminated. (In an Originated session, the host initiates LLC2 sessions;in a Terminated session, the host accepts sessions destined for the address.)A host-to-terminal connection is always initiated by the terminal.To configure a host, press [D] at the Configure IP/LLC2/BRIDGE/IPX Default Param-eters Menu. When prompted, enter:l Host Number: 0–128. (Default is 0.)l Any other requested information (if this is a new host), noting Table 9-4 (onpage 9-21).The resulting display will depend on the configured session type:Figure 9-6 = Originated, Figure 9-7 = Terminated.N ode Name=n odexyzC onfigure Brid ge/LLC2 Node DefaultsA Virtu al LAN ID 000B Bridge Enabled NC Bridge Hello Time 2D Bridge Max Age 20E Bridge Forward Delay 15F Bridge Aging Timer (seconds ) 300G Bridge Priority 0H Max Size Bridge Forwarding Table 65535I IP Bridging En abled NJ IPX Bridging Enabled NK SRB ID 0L Default Eth ernet Frame Type Type IIOption:
