Configuring Node Defaults 4-3Node Defaults ParametersThe parameters on the first two Node Defaults screens are listed in Table 4-1, and theNetView parameters on the third screen are listed in Table 4-2 (on page 4-6). Descrip-tions of most parameters follow each table.1 Remember that the software sees uppercase as different from lowercase.2 A value of 0 means that no status will be sent.3 If 0, the connection will remain active continuously.4 Continuous retries until connection is established.Node Nameis displayed at the upper right of the screen when the device is being controlled by the"local" keyboard and monitor. (If the local operator is controlling a remote Cabletronframe relay access device, the Remote Control ID of that device will be displayed as thelocal Node Name.)Remote Control IDis required if a remote Cabletron frame relay access device or async terminal will beused to take control of the local SmartSwitch 1800 (via a physical or logical port inthe local device). The ID will be checked against the called address fields of incomingCall Requests. The remote device can be a terminal connected to an async PAD porton a remote Cabletron frame relay access device, or the remote device itself.Table 4-1 Node Defaults ParametersParameter Valid Values Default ValueNode Name up to 8 characters noneRemote Control ID 0–15 digits noneRemote Control Pwd 0–15 characters 1 remoteFile Tr ansfer ID 0–15 digits noneFile Tr ansfer Pwd 0–15 characters 1 ftranCollecting Node ID 0–15 digits noneCollecting Node Pwd 0–15 characters 1 alarmsPrimary Alarm Output ID 1–15-digit address nonePrimary Alarm Output Pwd 0–15 characters 1 alarmsSecondary Alarm Output ID 1–15-digit address noneSecondary Alarm Output Pwd 0–15 characters 1 alarmsCollecting Node Y/N NMax Congestion 1–50 (%) 50Min Congestion 1–50 (%) 25Periodic Status Timer 0–30 (min) 2 1Line Idle Timer 0–65535 (sec) 0 3Alarm Autocall Timer 5–3600 (sec) 60Alarm Max Retries 0–99 0 (no max) 4
