FRM Configuring Frame Relay 7-7Figure 7-2 Bandwidth Allocation Group Menu[A],[A],[H] from Main MenuPressing [N] will display Page 2, which contains parameters for groups 5–8. Page 3contains groups 9–12, and Page 4 contains groups 13–16.Bandwidth Allocation Group ParametersExplanations of the parameters follow the table.Group "n" Percentageis a percentage of bandwidth that will be dedicated to traffic in a group if necessary.If the traffic does not require the full allocation, unused bandwidth will be available toother groups.The total percentage assigned to all sixteen groups can be greater than 100%. Thisallows allocating 100% to, for example, four or five groups that will be used for a par-ticular type of traffic, and 100% to another few groups, and so on. Since usage obvi-ously cannot exceed 100%, any allocation of greater than 100% will be treated as100%, with the percentages assigned to the affected groups treated as relative per-centages. For example, assume that Group 1 is assigned 60%, Group 2 is assigned70%, and both groups are assigned to IP interfaces. Under a full traffic load, Group 1Table 7-1 Bandwidth Allocation Group ParametersParameter Valid Values Default ValueDynamic Optimization is not currently supportedGroup "n" Percentage 0–100 100Group "n" Excess Priority 0–16 1Group "n" Use Excess Burst Y/N N: Nod e Name=node_xyzBandw id th A llocation Group (screen 1 of 4)A Dynamic Optimization NB Group 1 Percentage 0C Group 1 Excess Priority 1D Group 1 Use Excess Burst YE Group 2 Percentage 0F Group 2 Excess Priority 1G Group 2 Use Excess Burst YH Group 3 Percentage 0I Group 3 Excess Priority 1J Group 3 Use Excess Burst YK Group 4 Percentage 0L Group 4 Excess Priority 1M Group 4 Use Excess Burst YN Page 2Option:
