Turn and Lane-Change SignalsTo signal a turn, move the lever all the way up ordown. The lever returns automatically when the turn iscomplete.An arrow on the instrumentpanel cluster will flash inthe direction of theturn or lane change.Raise or lower the lever until the arrow starts to flashto signal a lane change. Hold it there until the lanechange is complete. The lever returns to its originalposition when it’s released.Arrows that flash rapidly when signaling for a turn orlane change may be caused by a burned-out signal bulb.Other driver’s won’t see the signal.Replace burned-out bulbs to help avoid possibleaccidents. Check the fuse and for burned-out bulbs ifthe arrow fails to work when signaling a turn. SeeFusesand Circuit Breakers on page 5-94 for more information.Turn Signal On ChimeIf the turn signal is left on for about 1 mile (1.6 km),a warning chime will sound and the Turn SignalOn message will appear on the Driver InformationCenter (DIC) display. See “Turn Signal On Message”underDIC Warnings and Messages on page 3-61for more information.Headlamp High/Low-Beam ChangerPush forward on the turn signal/multifunction lever tochange the headlamps from low to high beam.Pull the lever back and then release it to change fromhigh to low beam.This light on the instrumentpanel cluster will be on,indicating high-beamusage.3-10
