BrakesBrake FluidYour brake master cylinder reservoir is filled with DOT-3brake fluid. SeeEngine Compartment Overview onpage 5-12 for the location of the reservoir.There are only two reasons why the brake fluid level inthe reservoir might go down. The first is that thebrake fluid goes down to an acceptable level duringnormal brake lining wear. When new linings are put in,the fluid level goes back up. The other reason is thatfluid is leaking out of the brake system. If it is, youshould have your brake system fixed, since a leakmeans that sooner or later your brakes will not workwell, or will not work at all.So, it is not a good idea to “top off” your brake fluid.Adding brake fluid will not correct a leak. If you add fluidwhen your linings are worn, then you will have toomuch fluid when you get new brake linings. You shouldadd (or remove) brake fluid, as necessary, only whenwork is done on the brake hydraulic system.{CAUTION:If you have too much brake fluid, it can spill onthe engine. The fluid will burn if the engine ishot enough. You or others could be burned,and your vehicle could be damaged. Add brakefluid only when work is done on the brakehydraulic system.5-41