Advanced Guide > Scanning > Scanning with Other Application Software > Scanning with Advanced Settings UsingScanGear (Scanner Driver) > Scanning in Advanced ModeScanning in Advanced ModeIn Advanced Mode, you can specify the color mode, output resolution, image brightness, color tone, etc.when scanning.This section explains how to scan a single document from the Platen.See "Scanning Multiple Documents at One Time with ScanGear (Scanner Driver) " to scan multipledocuments at one time.See "Scanning Multiple Documents from the ADF (Auto Document Feeder) in Advanced Mode " to scanmultiple documents placed on the ADF (Auto Document Feeder).ImportantThe following types of documents may not be cropped correctly. In that case, click (Thumbnail)on the Toolbar to switch to whole image view and scan.- Photos that have a whitish border- Documents printed on white paper, hand-written text, business cards, etc.- Thin documents- Thick documentsThe following types of documents cannot be cropped correctly.- Documents smaller than 1.18 inches (3 cm) square- Photos that have been cut to various shapes1. Place the document on the Platen, then start ScanGear (scanner driver).Starting ScanGear (Scanner Driver)ImportantPlace the document face-down on the Platen and align an upper corner of the document withthe corner at the arrow (alignment mark) of the Platen.2. Click Advanced Mode.The Advanced Mode tab appears.Page 555 of 973 pagesScanning in Advanced Mode