Advanced Guide > Troubleshooting > Problems Sending FaxesProblems Sending FaxesCannot Send a FaxCannot Perform Sequential Broadcasting by Redialing, or Cannot Dial Using the Numeric ButtonsCannot Send a Fax ClearlyErrors Often Occur When You Send a FaxCannot Send a FaxCheck 1: Is the power turned on?You cannot send faxes if the power is turned off. Press the ON button to turn the poweron.If you disconnected the power cord without turning off the power (the Power lamp islit), reconnecting it turns on the power automatically.If you disconnected the power cord after pressing the ON button to turn off the power(the Power lamp is not lit), reconnect it, then press the ON button to turn on the power.If the power was turned off due to power failure, etc., the power is automatically turnedon when the power failure is resolved.Check 2: Is the document being sent from memory or the fax being received intomemory?When the In Use/Memory lamp is flashing, a fax is being sent from/received into memory.Wait until the transmission/reception is complete.Check 3: Is the telephone line connected to the External Device Jack?Reconnect it to the Telephone Line Jack. Refer to your setup manual.If you still cannot send a fax, there is a problem with the telephone line. Contact yourtelephone company and the manufacturer of your terminal adapter or telephone adapter.Check 4: Is the telephone line type set correctly?Check the telephone line type setting and change it as necessary.Confirming the Telephone Line ConnectionCheck 5: Is Hook key setting set to Disable?When you send a fax manually, dial the number with Hook key setting set to Enable, or dial thenumber using the telephone connected to the machine.Check 6: Is Dial tone detect set to ON?Resend the fax after a while. If you still cannot send the fax, set Dial tone detect to OFF.Dial tone detectCheck 7: Is the fax number registered correctly for speed dialing?Make sure that the fax number is registered correctly for speed dialing.. Registering Recipients for Speed DialingCheck 8: Does an error occur during transmission?Check the LCD for an error message.A Message for Faxing Is Displayed on the LCDPrint the Activity report and check for an error.Printing the Activity report manuallyCheck 9: Is the telephone line connected correctly?Page 890 of 973 pagesProblems Sending Faxes
