disabled.Replace the empty ink cartridge immediately after theprinting. The resulting print quality is not satisfactory, ifprinting is continued under the ink out condition.NoteIf the function for detecting the remaining ink level isdisabled, is displayed on the LCD.Routine MaintenanceSince the information contained in the fax may be lost ifit is printed in this condition, the received fax will not beprinted and will be stored in memory until the inkcartridge is replaced. You must manually print out faxesthat were stored in memory. You can change the settingso that the received fax is forcibly printed out instead ofbeing stored in memory, but all or part of the faxinformation may not be printed because of the ink outcondition.Contact service center The ink absorber is almost full.Press the machine's OK button to continue printing. Contactthe service center.Printer error has occurred5B00The machine error has occurred.Contact the service center.Timeout errorPress [OK]Some errors occurred while copying and a certain timepassed.Press the OK button to dismiss the error, and try to copyagain.Incompatible deviceDisconnect the cable from direct printportCheck the device connected to the Direct Print Port.Printing photos directly is possible with a PictBridgecompliant device or the optional Bluetooth Unit BU-30.A communication time out occurs if an operation takestoo long or if it takes too much time to send data. Thismay cancel printing. In such cases, disconnect andreconnect the USB cable.When printing from a PictBridge compliant device,depending on the model or brand of your device, you mayhave to select a PictBridge compliant print mode on thedevice before connecting it to the machine. You may alsohave to turn on your device or select Play mode manuallyafter connecting the device to the machine. Performnecessary operations before connecting your devicereferring to its instruction manual.If the error is still not resolved, check if you can printanother photograph.Failed to scan the head alignmentsheetPress [OK]Scanning the print head alignment sheet has failed.Press the OK button to dismiss the error, then take theactions described below.Make sure that the print head alignment sheet is set inthe correct position and orientation on the Platen Glass.Make sure the Platen Glass and the print head alignmentsheet are not dirty.Make sure the type and size of loaded paper is suitablefor Automatic Print Head Alignment.For Automatic Print Head Alignment, always load onesheet of A4 or letter-sized plain paper.Make sure if Print Head nozzles are clogged.Print the nozzle check pattern to check the status of thePrint Head.Routine MaintenancePage 813 of 973 pagesAn Error Message Is Displayed on the LCD
