Upgrading via Internet■ OverviewSelect to automatically install the firmware update without using a computer.■ Preparation1. Check that there are no other jobs being executed.2. In an environment where access is obtained via a proxy server, the proxy setting is made from the remote UI.Settings/Registration > System Management Settings > Network Settings >TCP/IP Settings > Proxy Settings > Edit... > UseProxy(select)Select the [Use Proxy] check box and specify the required settings.3. Check that the serial number of the host machine is shown on the Main Controller PCB.NOTE:To upgrade the firmware of the host machine via Internet, the serial number of the machine need to be written on the Main ControllerPCB.Execute COPIER > FUNCTION > MISC-P > SPEC, and check that the BODY No. is registered.If the BODY No. has not been registered, register the serial number.■ Procedure1. Press the [Menu] key, and update the firmware via the Internet in user mode.System Management Settings > Update Firmware > Via InternetNOTE:• Refer to the User's Manual of the device for how to connect the device to the external network.• This is applicable either in a wired LAN environment or a wireless LAN environment.■ MessagesThe message displayed on the device operation panel is as follows.No. Error message The timing of oc-currenceRemedy1 Job in progress...Wait a moment, then try again.If there is a job beingexecuted:1. Wait until the job is completed.2. Cancel the job.2 Cannot check the firmware version.(Server communication error.)Network error 1. Check whether the device can be connected to the ex-ternal network.2. Check whether the proxy setting has been made (in caseof access via a proxy server).3 Cannot download the firmware.(Error during download.)1. Check whether the device can be connected to the ex-ternal network.2. Check whether the proxy setting has been made (in caseof access via a proxy server).3. Check that the serial number of the host machine isshown on the Main Controller PCB.4 ***DOWNLOAD MODE***NETWORK AVAILABLE IP ADRESSIP address of the machinePRESS STOP KEY TO EXITIf update (writing) ofthe firmware hasended in failure:1. Update the firmware again using UST.5 ***DOWNLOAD MODE***FAILED TO UPDATE6 ***DOWNLOAD MODE***UPDATE IS COMPLETEIf the update of thefirmware is successful-6. Troubleshooting247
