TESTMODE > FAX > MODEMItem DescriptionDisplay/adj/set range 0 to 6140: OFF• First digit (Modulation speed/baud rate)1: 2400 baud2: 2743 baud3: 2800 baud4: 3000 baud5: 3200 baud6: 3429 baud• Last 2 digits (Transmission speed)01: 2400 bps02: 4800 bps03: 7200 bps04: 9600 bps05: 12000 bps06: 14400 bps07: 16800 bps08: 19200 bps09: 21600 bps10: 24000 bps11: 26400 bps12: 28800 bps13: 31200 bps14: 33600 bpsDefault value 0■ FACULTYFAX model onlyTESTMODE > FAX > FACULTYItem DescriptionG34800TXTitle G3 4800 bps signal transmission testDetails To test whether the G3 signal is transmitted at 4800 bps.By closing or opening the DC circuit, the specific G3 signal pattern is transmitted at 4800 bps bythe G3 signal transmission function.Check this with the speaker.Adj/set/operate method Enter the setting value, and then press Apply key.Caution Be sure to set the value back to 0 after the test.Display/adj/set range 0 to 10: OFF1: ONDefault value 0DETECT1Title Ring detectionDetails To check the ON/OFF state of CI, FC, and hook from the line.The detection results are displayed on the console (UART).Adj/set/operate method Enter the setting value, and then press Apply key.Caution Be sure to set the value back to 0 after the test.Display/adj/set range 0 to 10: OFF1: ONDefault value 0Supplement/memo CI (Calling Identification): Ring signal UART (Universal Asynchronous Receiver Transmitter): Con-soleDETECT2Title Calling tone detection test 18. Service Mode312
