COPIER > FUNCTION > SPLMANItem DescriptionAdj/set/operate method Select the item, and then press Apply key.Display/adj/set range 0 to 10 : OFF1 : ONDefault value 0SPL41971Title Execution of curl prevention mode 1Details To extend the initial rotation time and paper interval, and lower the control temperature.Use case When paper which has been printed is curled toward the printed side depending on the paper type,environment (especially in a low humidity environment) or print pattern (especially high printing ratio)Adj/set/operate method Select the item, and then press Apply key.Display/adj/set range 0 to 10 : OFF1 : ONDefault value 0Related service mode COPIER > FUNCTION > SPLMAN > SPL69399SPL35607Title Execution of down sequence prevention modeDetails Execute this mode when down sequence occurs.To lower the control temperature of the Fixing Assembly without exception.Use case When down sequence occursAdj/set/operate method Select the item, and then press Apply key.Caution Be sure to get approval from the user in advance by explaining that there is a possibility that fixingfailure may occur depending on the paper type by lowering the fixing control temperature.Display/adj/set range 0 to 10 : OFF1 : ONDefault value 0SPL37510Title ON / OFF of ITB cleaning at paper size mismatchDetails Normally, when paper other than that of the specified size is fed, ITB cleaning is executed to removetoner. When 1 is set, ITB cleaning is not executed even if paper size is mismatched. Productivityimproves, but toner soiling may occur.Use case When paper size is mismatchedAdj/set/operate method Enter the value, and then press Apply key.Caution Be sure to get approval from the user by telling that toner soiling may occur to improve productivity.Display/adj/set range 0 to 10 : OFF1 : ONDefault value 0SPL65677Title Increase of paper leading edge marginDetails To increase the margin on the leading edge of paper.As the value is incremented by 1, the margin is increased by 0.1 mm. The value obtained by addingthis value and SPL68676 (decrease of the margin) is applied.Adj/set/operate method 1. Enter the setting value, and then press Apply key.2. Turn OFF/ON the main power switch.Display/adj/set range 0 to 20Unit 0.1 mmDefault value 0Related service mode COPIER > FUNCTION > SPLMAN > SPL68676SPL68676Title Decrease of paper leading edge marginDetails To decrease the margin on the leading edge of paper.As the value is incremented by 1, the margin is decreased by 0.1 mm.The value obtained by adding this value and SPL65677 (increase of the margin) is applied.8. Service Mode285
