E-RDS Setup■ Confirmation and preparation in advanceTo monitor this machine with e-Maintenance/ imageWARE Remote, the following settings are required.● Advance preparationsThe following network-related information needs to be obtained from the user's system administrator in advance.Information item 1IP address settings• Automatic setting : DHCP• Manual setting : IP address, subnet mask and gateway address to be setInformation item 2Is there a DNS server in use?If there is a DNS server in use, find out the following.• Primary DNS server address• Secondary DNS server addressInformation item 3Is there a proxy server?If there is a proxy server in use, find out the following.• Proxy server address• Port No. for proxy serverInformation item 4Is proxy server authentication required?If proxy server authentication is required, find out the following.• User name and password required for proxy authentication● Network settingsBased on the results of the information obtained in "Advance preparations", make this machine network related settings.See Users' Guide for detailed procedures.CAUTION:When changes are made to the above-mentioned network settings, be sure to turn OFF and then ON the main power ofthis machine.■ Steps to E-RDS settings1. Start [SERVICE MODE].2. Select [COPIER] > [FUNCTION] > [CLEAR] > [ERDS-DAT] and touch the [Yes].NOTE:This operation initializes the E-RDS settings to factory setting values.For the setting values to be initialized, see the section of “Initialization procedure” on page 50.3. Select [COPIER] > [FUNCTION] > [INSTALL] > [ERDS].2. Technical Explanation49
