E Code Detail Code Item DescriptionE014 0001 Title Revolution of the Fixing Motor was out of the specified rangeDescription After the cycle of the Fixing Motor speed detection signal became the specified cycle once, itdeviated from the specified cycle.Remedy 1. Check the connector between the ITB Motor and the DC Controller PCB.2. Replace the ITB Motor.3. Replace the DC Controller PCB.E015 0001 Title Error in Developing Disengagement MotorDescription Change in signal status of the Developing Home Position Sensor could not be detected al-though a specified period of time has passed after rotating the Main Motor for engagement/disengagement operation of the Developing Cylinder.Remedy 1. Check the connectors connecting the Developing Home Position Sensor, Main Motorand the DC Controller PCB.2. Replace the Developing Home Position Sensor.3. Replace the Main Motor.4. Replace the DC Controller PCB.E020 0000 Title Density Sensor errorDescription Sufficient amount of light could not be received when detecting image density.Remedy 1. Check the connector of the DC Controller PCB.2. Replace the ITB Unit.3. Replace the DC Controller PCB.4. Replace the Toner Cartridge.E021 1003 Title Developing Motor errorDescription The Developing Motor failed to rotate.Remedy 1. Check the connector between the Developing Motor and the DC Controller PCB.2. Replace the Developing Motor.3. Replace the DC Controller PCB.E021 2003 Title Developing Motor errorDescription The cycle of the Developing Motor speed detection signal did not become the specified cyclesince the Developing Motor started to be driven.Remedy 1. Check the connector between the Developing Motor and the DC Controller PCB.2. Replace the Developing Motor.3. Replace the DC Controller PCB.E052 0000 Title Duplex Unit detection errorDescription Duplex Unit detection errorRemedy 1. Check the connector between the Duplex Unit and the DC Controller PCB.2. Replace the DC Controller PCB.E066 0000 Title Environment Sensor errorDescription Environment Sensor errorRemedy 1. Check the connector between the Environment Sensor and DC Controller PCB.2. Replace the Environment Sensor.3. Replace the DC Controller PCB.E070 0000 Title ITB/TOP Sensor errorDescription ITB/TOP Sensor errorRemedy 1. Check the connector between the ITB Unit and DC Controller PCB.2. Replace the ITB Unit.3. Replace the DC Controller PCB.E078 0000 Title Primary transfer disengagement errorDescription Primary transfer disengagement mechanism did not work properly.Remedy 1. Check the disengagement mechanism.2. Check the connectors of the ITB Tension Sensor, Developing Motor, and DC ControllerPCB.3. Replace the ITB Tension Sensor.4. Replace the Developing Motor / DC Controller PCB.E100 0000 Title Error in Laser Scanner Motor or Laser Scanner Unit (Y)Description Error in the BD detection value in the Laser Scanner Motor or the Laser Scanner Unit (Y)Remedy 1. Check the connector between the Laser Scanner Unit and the DC Controller PCB.2. Replace the Laser Scanner Unit.3. Replace the DC Controller PCB.E100 0001 Title Error in Laser Scanner Motor or Laser Scanner Unit (Y)7. Error/Jam/Alarm253
