CHAPTER 9 INSTALLATION9-28 COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)WorkPerform the following while toner isbeing supplied.1. Remove the screw used to keepthe center of the right cover inplace, and install the original trayto the machine (right) with twostepped screws. (You will not beusing the removed screw.)2. Attach the mode memory sheet tothe cover of the toner supplymouth.Reference:If you find installing the originaltray difficult, loosen the twomounting screws and start over.Attach the Manual Feed Instructionslabel to the manual feed tray of theRDF.When the toner supply operation hasended, place the Test Sheet on thecopyboard, make copies, and checkthe copy images.At times, toner can fall from the drumseparation claws, soiling the initialten or so copies. (This phenomenonwill disappear as copies are made.)Check to make sure that pick-upfrom each source is normal.Make two-sided/overlay copies.Step12131415Remarks• Check to make sure that no abnormal soundis heard.• Check images of copies made at each defaultratio.• Check to make sure that as many copies asset are made.• If there is a difference in density between leftand right, adjust the height of the rear of theprimary charging wire to correct.• Check to make sure that copying operation isnormal.• Check to make sure that abnormal noise isnot heard.• Check to make sure that paper feeding in theholding tray assembly is normal.LabelStepped screwsOriginal tray
