III. RELOCATING THE MACHINEIf you must relocate the machine after installation by truck or other means oftransportation, perform the following steps:A. Observe the following if you are using stairs when moving the machine into or outof the user’s:1. Be sure to remove the fixing/feeding unit assembly, holding tray, and copy paper;and ship them separately from the machine. (If an RDF is installed, be sure todetach it also.)2. When lifting the machine, do not use the grips on the pick-up assembly/deliveryassembly; rather, support it at the four corners of its bottom.B. Check to make sure that the two adjusters (front) on the bottom of the machine arefacing up and released. The adjusters can slip out; take care not to lose them.C. When moving the machine in and out of the site of installation, be sure to removethe Paper Deck-A1 (accessory).CHAPTER 9 INSTALLATION9-31COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)WorkMake a copy in Direct.Remove all copy paper from theleft/right paper deck and each cassette.Turn off the power switch, anddisconnect the power plug from thepower outlet.Fix the No. 2 mirror mount in place withthe locking plate from the left coverside.Remove the developing assembly.Tape the following in place so that theywill not be shaken out of place duringtransport: transfer charging assembly,fixing/feeding unit assembly releasinglever, holding tray assembly, andholding tray feeding assembly.Tape the following in place: front door,hopper cover, each cassette, left/rightpaper deck cover, and machine rightdoor (upper/lower).Place A3 copy paper on the copyboardglass, and tape the copyboard cover orthe RDF in place.Step12345678ChecksCheck to make surethat the lens is withinlens hood.Check to make surethat the No. 2 mirrormount will not move.Ship the developingassembly separately.RemarksCaution:
