• For LMP1 and LMP2, the activation control voltage value is indicated even whenthe scanning lamp is off.If a value other than ‘0’ is indicated for ‘WIRE’ because of an error in the chargingcleaner, be sure to execute ‘wire cleaning’ in user mode.If the wire cleaner motor and the wire cleaner unit are normal, executing wire clean-ing turns on the cleaner unit and stops it at home position, clearing the indication to‘0’.(Unless you execute wire cleaning, the associated operation is prohibited and themachine will not be reset even when the machine is turned off and on.)CHAPTER 11 TROUBLESHOOTING11-161COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)ItemLIFTDescriptionIndicates ‘1’ if the lifter position sensor does not turn onwithin 13 sec after the UP command for the lifter (paperdeck/cassette) has been issued.Order of Indication• Paper Deck Typeright deck, left deck, cassette 3, cassette 4, side paperdeck (if installed)RemarksResetting is byturning OFF andON the powerswitch.Caution:
