Configuring System Information 169• Accounting Mode — Use the menu to select whether the RADIUS accounting mode is enabled ordisabled on the current server.• RADIUS Attribute 4 (NAS-IP Address) — To set the network access server (NAS) IP address for theRADIUS server, select the option and enter the IP address of the NAS in the available field. Theaddress should be unique to the NAS within the scope of the RADIUS server. The NAS IP address isonly used in Access-Request packets.Configuring Global RADIUS Settings Using CLI CommandsFor information about the CLI commands that perform this function, see the RADIUS Commandschapter in theCLI Reference Guide. The following table summarizes the equivalent CLI commands youuse.RADIUS Server ConfigurationFrom the RADIUS Server Configuration page, you can add a new RADIUS server, configure settings fora new or existing RADIUS server, and view RADIUS server status information. The RADIUS client onthe switch supports up to 32 named authentication and accounting servers.To access the RADIUS Server Configuration page, click System →Management Security →RADIUSServer Configuration in the tree view.Table 6-31. RADIUS Global CommandsCLI Command Descriptionradius-server attribute Sets the network access server (NAS) IP address for the RADIUSserver.radius-server retransmit Specifies the number of times the software searches the list ofRADIUS server hosts.radius-server timeout Sets the interval for which a switch waits for a server host to reply.show radius-servers Displays the RADIUS server settings.
