Configuring System Information 263Target Name — Identifies the iSCSI name of the iSCSI target. The name can be statically configured;however, it can be obtained from iSNS or from sendTargets response. The initiator MUST present bothits iSCSI Initiator Name and the iSCSI Target Name to which it wishes to connect in the first loginrequest of a new session or connection.Remove — To remove an iSCSI target from the table, select the Remove option and click ApplyChanges.Adding an iSCSI Target1. Open the iSCSI Targets Table page.2. Click Add.The Add iSCSI Table page displays:Figure 6-130. Add iSCSI Target3. Define the relevant fields.4. Click Apply Changes.5. The target is added to the iSCSI targets table, and the device is updated.Viewing the iSCSI Targets Table and adding Static iSCSI Targets Using CLI CommandsFor information about the CLI commands that perform this function, see the following chapter in theCLI Reference Guide:• iSCSI Commands.iSCSI SessionsUse the iSCSI Sessions page to view information about the iSCSI sessions that the switch hasdiscovered. An iSCSI session occurs when an iSCSI initiator and iSCSI target communicate over one ormore TCP connections. The maximum number of iSCSI session is 192.To access the iSCSI Sessions page, click System →iSCSI →Sessions in the navigation tree.
