Configuring Routing 563Displaying the Best Routes Table Using CLI CommandsFor information about the CLI command that performs this function, see the following chapter in theCLI Reference Guide:• IP Routing CommandsThe following table summarizes the equivalent CLI commands for this feature.Route Entry ConfigurationUse the Router Route Entry Configuration page to add new and configure router routes.To display the page, click Routing →Router →Route Entry Configuration in the tree view.Figure 9-36. Router Route Entry ConfigurationThe Router Route Entry Configuration page contains the following fields:• Network Address — Specify the IP route prefix for the destination from the drop-down menu. In orderto create a route, a valid routing interface must exist and the next hop IP Address must be on the samenetwork as the routing interface. Routing interfaces are created on the IP Interface Configurationpage. Valid next hop IP Addresses can be viewed on the Route Table page.• Subnet Mask — Also referred to as the subnet/network mask, this indicates the portion of the IPinterface address that identifies the attached network.• Protocol — This field tells which protocol created the specified route. Possible values are:Table 9-32. Best Routes Table CommandCLI Command Descriptionshow ip route preferences Displays detailed information about the route preferences.
