724 Configuring IP MulticastSetting the IGMP Mode1. Open the IGMP Global Configuration page.2. Set Admin Mode to Enable or Disable, to turn IGMP on or off.3. Click Apply Changes.The IGMP configuration is saved, and the device is updated.Setting IGMP Mode Using CLI CommandsFor information about the CLI commands that perform this function, see the following chapter in theCLI Reference Guide:• IGMP CommandsThe following table summarizes the equivalent CLI commands for this feature.Routing InterfaceThe Routing Interface menu page contains links to web pages that configure and display IGMP routingparameters and data. To display this page, click IPv4 Multicast →IGMP →Routing Interface in the treeview. Following are the web pages accessible from this menu page:• IGMP Interface Configuration• IGMP Configuration Summary• IGMP Cache Information• IGMP Interface Source List InformationIGMP Interface ConfigurationUse the IGMP Interface Configuration page to configure and/or display router interface parameters.You must configure at least one valid routing interface before you can access this page and configure IPMulticast IGMP.To display the page, click IPv4 Multicast →IGMP →Routing Interface →Interface Configuration in thetree view.Table 12-14. IGMP Global CommandsCLI Command Descriptionip igmp Sets the administrative mode of IGMP in the system to active.show ip igmp Displays system-wide IGMP information.
