558 Configuring RoutingConfiguring Router Discovery Using CLI CommandsFor information about the CLI commands that perform this function, see the following chapter in theCLI Reference Guide:• Router Discovery Protocol CommandsThe following table summarizes the equivalent CLI commands for this feature.Router Discovery StatusUse the Router Discovery Status page to display Router Discovery data for each port.To display the page, click Routing →Router Discovery →Status in the tree view.Table 9-29. Router Discovery CommandsCLI Command Descriptionip irdp Enables Router Discovery on an interface.ip irdp address Configures the address that the interface uses to send the routerdiscovery advertisements.ip irdp holdtime Configures the value, in seconds, of the holdtime field of the routeradvertisement sent from this interface.ip irdp maxadvertinterval Configures the maximum time, in seconds, allowed between sendingrouter advertisements from the interface.ip irdp minadvertinterval Configures the minimum time, in seconds, allowed between sendingrouter advertisements from the interface.ip irdp preference Configures the preference of the address as a default router addressrelative to other router addresses on the same subnet.
