Configuring Quality of Service 6912. Click the Restore Defaults check box.3. Click Apply Changes.Queue values are returned to their defaults, and the device is updated.Mapping Table Configuration Using CLI CommandsFor information about the CLI commands that perform this function, see the following chapter in theCLI Reference Guide:• QoS CommandsThe following table summarizes the equivalent CLI commands for this feature.Interface ConfigurationUse the Interface Configuration page to specify ports individually for CoS configuration and to apply aninterface shaping rate to the selected ports.To display the Interface Configuration page, click Quality of Service →Class of Service →InterfaceConfiguration in the tree view.Table 11-8. Mapping Table Configuration CommandsCLI Command Descriptionclassofservice dotlp-mapping Maps an 802.1p priority to an internal traffic class for a switch.classofservice ip-dscp-mapping Maps an IP DSCP value to an internal traffic class.classofservice trust Sets the class of service trust mode of an interface.show classofservice dotlp-mapping Displays the current Dot1p (802.1p) priority mapping to internaltraffic classes for a specific interface.show classofservice ip-dscp-mapping Displays the current IP DSCP mapping to internal traffic classes for aspecific interface.show classofservice trust Displays the current trust mode setting for a specific interface.show interfaces cos-queue Displays the class-of-service queue configuration for the specifiedinterface.
