552 Configuring RoutingDisplaying RIP Interface Summary Using CLI CommandsFor information about the CLI command that performs this function, see the following chapter in theCLI Reference Guide:• Routing Information Protocol (RIP) CommandsThe following table summarizes the equivalent CLI commands for this feature.RIP Route Redistribution ConfigurationUse the RIP Route Redistribution Configuration page to configure the RIP Route Redistributionparameters. The allowable values for each fields are displayed next to the field. If any invalid values areentered, an alert message is displayed with the list of all the valid values.Static Reject RoutesA static reject route is a static route to discard the packets to a particular destination, thereby forcing ablack-hole routing behavior for a particular set of IP prefixes. Static reject routes can help prevent arouting loop in the network if a default route is configured on a router. Static reject routes also helpprotect against a DOS attack on a router with unwanted destination addresses.NOTE: Static reject routes are not redistributed by OSPF or RIP.Starting with software release 3.0, you can select Static Reject as a route type from the Route Type fieldon the following pages under the Routing →Router menu:• Route Entry Configuration• Configured RoutesNOTE: For a static reject route, the next hop interface value is Null0. Packets to the network address specified instatic reject routes are intentionally dropped.To display the page, click Routing →RIP →Route Redistribution Configuration in the tree view.Table 9-26. RIP Interface Summary CommandCLI Command Descriptionshow ip rip interface brief Displays general information for each RIP interface.
