760 Configuring IP Multicast• Admin Mode — Select Enable or Disable from the drop-down menu to set the administrative statusof PIM for the selected interface. The default is Disable.• Hello Interval — Enter the number of seconds between PIM hello messages transmitted from theselected interface. The default value is 30. Valid values are 0 to 65535 seconds.• Join Prune Interval — Enter the frequency at which PIM Join/Prune messages are transmitted on thisPIM interface. The valid values are from (0 to 65535). The default value is 60.• BSR Border — Indicates whether this interface is enabled or disables to act as a border for all PIMbootstrap messages. Bootstrap messages do not cross the BSR border.• DR Priority — The Designated Router priority value. The router with the highest priority value iselected as the Designated Router. A shared-media such as Ethernet may have multiple PIM-SMrouters connected to it. A single one of these routers, the DR, acts on behalf of directly connectedhosts with respect to the PIM protocol. This field is applicable for PIM-SM only. The valid values are 0to 2147483647.Configuring PIM for an Interface1. Open the PIM Interface Configuration page.2. Select the interface to configure from the Interface field.3. Modify the remaining fields as needed.4. Click Apply Changes.The interface configuration is saved, and the device is updated.Configuring PIM for an Interface Using CLI CommandsFor information about the CLI commands that perform this function, see the following chapter in theCLI Reference Guide:• PIM-DM or PIM-SM CommandsThe following table summarizes the equivalent CLI commands for this feature.Interface SummaryUse the PIM Interface Summary page to display a PIM interface and its settings.To display the page, click IPv4 Multicast →PIM →Interface Summary or IPv6 Multicast →PIM →Interface Summary in the tree view.Table 12-34. PIM Interface CommandsCLI Command Descriptionip pimdm mode Sets administrative mode of PIM-DM on an interface to enabled.ip pimsm mode Sets to enabled the administrative mode of PIM-SM multicast routingon a routing interface.
