2 Hardware Specifications and WiringDVP-PM Application Manual 2-12.1 Hardware SpecificationsThis chapter only provides information on electrical specification and wiring. For detailed information on programdesign and instructions, please refer to Chapter 5 ~ 6. For how to purchase its peripheral devices, please refer to theinstruction sheet enclosed with the product.2.1.1 Electrical Specifications20PM 10PMPower supplyvoltage 100 ~ 240V AC(-15% ~ 10%), 50/60Hz ± 5%Power supply fuse 2A/250VACPower consumption 60VADC24V currentoutput 500mAPower supplyprotection DC24V; output short-circuit protectionVoltage withstand 1,500VAC (Primary-secondary); 1,500VAC (Primary-PE); 500VAC (Secondary-PE)Insulationresistance > 5MΩ (all I/O point-to-ground: 500VDC)Noise immunity ESD: 8KV Air Discharge; EFT: Power Line: 2KV, Digital I/O: 1KV, Analog & CommunicationI/O: 250VGrounding The diameter of grounding wire shall not be less that of L, N terminal of the power. (Whenmany PLCs are in use at the same time, please make sure every PLC is properly grounded.)Environment Operation: 0°C ~ 55°C (temperature), 50 ~ 95% (humidity), pollution degree 2Storage: -25°C ~ 70°C (temperature), 5 ~ 95% (humidity)Vibration/shockresistanceInternational standards: IEC61131-2, IEC 68-2-6 (TEST Fc)/IEC61131-2 & IEC 68-2-27(TEST Ea)Weigh (approx. g.) 478/6882.1.2 I/O Point SpecificationsInput point specifications: DVP20PM00DMax. inputTerminal Description Responsetime Current VoltageSTART0, START1 For input signals of Start 10ms 6mA 24VSTOP0, STOP1 For input signals of Stop 10ms 6mA 24VLSP0/LSN0,LSP1/LSN1 Right limit input/left limit input 10ms 6mA 24VA0+, A0-, A1+, A1- MPG A-phase pulse input +, - (differential signalinput) (A1+, A1- are shared by Y and Z ) 200kHz 15mA 5 ~ 24VB0+, B0-, B1+, B1- MPG B-phase pulse input +, - (differential signalinput) (B1+, B1- are shared by Y and Z) 200kHz 15mA 5 ~ 24V