10 Encrypting User ProgramDVP-PM Application Manual10-2a.) Click motion subroutine to unfold it. b.) Click subroutine to unfold it. Applying encryption to specific program:1. Right click the motion subroutine or P subroutine number to be encrypted and select “EnableProtection” as shown in a.) below.2. The encrypted program number will have a “_(P)” mark after it, meaning the program has beenprotected, as shown in b.) below. Ox_(1P) means “1” motion subroutine will be encryoted, and Ox_4(P)means “4” motion subroutines will be encrypted. The same rule also applies to P subroutines. However,there is only 1 main program; therefore, enable the protection directly on O100 and make it O100_(P).a.) Right click the number and select “EnableProtection”.b.) 5_(P) refers to Ox5 will be encrypted Removing the protection1. Right click the motion subroutine or P subroutine and select “Disable Protection”, as shown in a.)below.2. The “_(P)” mark after the encrypted program number will be removed as shown in b.) below. P_(3P)refers to 3 subroutines are encrypted. After 1 protection is removed, it will become P_(2P).
