13 CANopen Communication CardDVP-PM Application Manual 13-275. Set up the IP of the created device. Click the created device and enter its IP in “CommunicationParameter” column to configure the IP address of one DVP-FPMC. The setting procedure of the otherDVP-FPMC is the same. Create Link4 and specify its IP as well.6. After the devices are created, create an object in the editing area. Click the object and click the iconin the Property column to open the input window of Write Address / Read Address. Select thecreated device (Link3) in “Link”. In this way, the object can be operated to control the devices of Slavethrough Ethernet.Design the buttons Y0~Y7 for both DVP-PM according to the above procedure as the disgram below.Buttons Y0~Y7 corre spond to Y0~Y7 of Link3 (Slave1) and Link4 (Slave2). When the above settingsare completed, the Ethernet connection between HMI and the 2 DVP-PM can be performed.IP: 192.168.0.100IP: 192.168.0.10113.7.2 Communication between DVP-FPMC and PMSoftPMSoft is featured with Ethernet function through DVP-FPMC. The ethernet communication interfacebetween DVP-PM and PC supports software functions including program download/upload andmonitoring on PMSoft. Hardware SettingsFor external wirings, the user only needs to connect the Ethernet COM ports on DVP-FPMC and PCthrough an Ethernet cable. When connecting with PC, the Ethernet indicator on DVP-FPMC will be ON innomal connection status. If the indicator is OFF, please check the hardware configuration or PC settings.
