Eaton 93PM IAC-T Series Installation And Operation Manual

Eaton 93PM Integrated Accessory Cabinet-Tie (50 kW and 100 kW IAC-T) Installation and Operation Manual P-164000371—Rev 05 33CChhaapptteerr 44 IInnssttaallllaattiioonnThis chapter includes planning and unpacking for the Integrated Accessory Cabinet-Tie (IAC-T).44..11 PPrreelliimmiinnaarryy IInnssttaallllaattiioonn IInnffoorrmmaattiioonnWARNINGInstallation should be performed only by qualified personnel knowledgeable of batteries and the requiredprecautions.Observe these precautions while installing the Integrated Accessory Cabinet-Tie (IAC-T):• Remove watches, rings, or other metal objects.• Use tools with insulated handles.• Wear voltage rated gloves and electrical hazard footwear.• Do not lay tools or metal parts on top of batteries or battery cabinets.• Refer to the Chapter 3 Installation Plan and Unpacking for cabinet dimensions, equipment weight,wiring and terminal data, and installation notes.• Do not tilt the cabinets more than 10° during installation.• Remove conduit landing plates to add conduit landing holes as required.Failure to follow these instructions may result in severe injury or death.44..22 UUnnllooaaddiinngg tthhee IIAACC--TT ffrroomm tthhee PPaalllleettThe IAC-T is bolted to a pallet consisting of four metal angle supports secured to two wood supports.WARNINGThe IAC-T is heavy (see Table 1). If unpacking and unloading instructions are not closely followed, the cabinetmay tip and cause serious injury.CAUTION• Do not tilt cabinet more than 10° from vertical.• Lift the cabinet only with a forklift or damage may occur.NOTE For the following steps, verify that the forklift or pallet jack is rated to handle the weightof the cabinet (see Table 1 for cabinet weights).To remove the pallet:1. If not already accomplished, use a forklift or pallet jack to move the IAC-T to the installation area, or asclose as possible, before unloading from the pallet. Insert the forklift or pallet jack forks between thesupports on the bottom of the pallet (see Figure 7 for the UPS cabinet center of gravity measurements).2. Open the front door by lifting the latch from the bottom and turning to the right (counterclockwise) andswing the door open.