Eaton CEAG AT-S+ Series Mounting And Operating Instructions

Also see for CEAG AT-S+ C30: Operating instructions

Contents

305 Transport, Packaging and StorageMANUAL CEAG AUtoMAtiC tEst systEM At-s+ 40071860177 (C) December 2016 www.ceag.de5 Transport, Packaging and Storage5.1 Safety NotesWARNING! RISK OF INJURYThere is a risk of injury when transporting or loadingdue to falling partsATTENTION!DAMAGE TO PROPERTY!The system will be destroyed or damaged byimproper transportThe following safety notes have to be observed:• Never lift loads over person´s head.• Always move the system with great care and attention.• Only use lifting accessories and hoisting devices withenough loading capacity.• Always handle and store the AT-S+ system upright (seemarkings and „do not tilt“ sign on the pack)• Avoid ingress of dust and moisture during handling.• Ensure that all transport routes– are clear (sufficient width and headroom for all trans-port movements),– provide enough room for persons to take evasiveaction if loads tip over or slip,– have sufficient loadbearing capacity (for the load,transport packaging and handling equipment)– could not overstrain the used transport equipment inregard of increase and constitution of underground.• Use only– handling equipment (e. g. pallet trucks, fork trucks,etc.)– slinging equipment (lifting beams, chains, ropes, etc.)– and securing equipment (chocks, timbers, guide/tensioning/securing ropes, etc.)that are in technically perfect condition and of adequateloadbearing capacity.• Follow all information shown on the transport packagingand/or on the device/control cabinet relating to handling,transport position, slinging points.• The equipment must be handled by persons familiarwith the appropriate procedures and signals and able tocarry out the handling operations properly and with dueregard to safety and hazard procedures.5.2 Transport inspectionCheck delivery on receipt for completeness and fortransport damages, immediately. If external damage isdetected do not accept the delivery, except under protest.5.3 PackagingIf no return – agreement exists for packing material sepa-rate it according to type and size for further use.ATTENTION!DAMAGE TO PROPERTY!Packing material has to be recycled in anenvironmentally friendly way and according to thelocal provisions governing disposal If necessary,commission special recycling companyObserve notes for handling printed on the packing material!5.4 StorageKeep packages closed up to mounting and observe theexternal marked arrangement and storage notes.Store packages under the following conditions:• Not to be stored outside• Keep dry and dust-free• The storage location should be clean and tidy• The time of storage should be as short as possible(FIFO-method)• It is forbidden to stack one pallet/system above the other