568 OperatingMANUAL CEAG AUtoMAtiC tEst systEM At-s+ 40071860177 (C) December 2016 www.ceag.de8.4.6 Menu 6 “Luminaire setup” Select line 1, 2, 4 or the input fields inline 1 with Successive selection of moduleand (final) circuit with (e.g. module 8, (final) circuit 2) Line 3 shows the current settings forthe luminaires (1 to 20) in the selectedcircuitLuminaire is present (Item 1)– no luminaire set up (Item 2) Select a luminaire (line 2) with(e.g. cursor flashing on position 3)Line 4 displays, for example, the mes-sage “Luminaire text” as default or aluminaire name if previously entered Changing the luminaire name:– Select line 4 with– Select the input point with– All the possible alphanumericcharacters are displayed cycli-cally with the cursor keys.– Once a name has been fullyentered, confirm the entry with. The remaining charactersafter the current cursor positionare cleared.Notes:You can use this menu to view luminaireassignments and assign / edit luminairenames without changing the luminaireconfiguration.The procedure is necessary, for examplewhen the system is first commissionedor after luminaires have been added orremoved.These luminaire names are stored on thememory card and displayed in the graphicdisplay menus as operator help. Text assign-ments cannot be made with theCU S+ if a memory card is not inserted!Otherwise, refer to menu option 4.2Overview:Main menuTest & status menuBlock & reset alarmsBasic settingsDLS/TLS SetupCircuit setupLuminaire setupLogbooksetupMenu 6Add / removeLuminaire searchText assignmentsDLS/TLS-Assignment Selection ofmenu optionswith the keys :confirm selec-tion -cel and returnto the previousmenu (anychanges en-tered are saved) : canceland return tothe previousmenu (anychanges en-tered are notsaved)flashing inputprompt Menu 6.1:Module8 circuit:2...5...10...15...20-—————————-Circuit nameMenu 6.3: Module8 circuit:2...5...10...15...20-—————————-Circuit nameAdd / removeLuminaire searchText assignmentsDLS/TLS-Assignment Select line 1 or the input fields in line1 with Successive selection of module and(final) circuit with Line 3 shows the current settings forthe luminaires (1 to 20) in the selectedcircuit:Luminaire is present (Item 1)– no luminaire set up (Item 2) Select a luminaire (line 2) with (e.g. cursor flashing on position 3)Line 4 displays the luminaire text(Name if previously entered).Use the key to set or remove aluminaire at the selected position.Notes:Only “present”( ) or “not present”(–) isdisplayed on positions 1 to 20. Individualluminaires can also be selectively taken outof service (not present) in this way.Condition and/or switched status can bepolled for CG-S luminaires in menu 1.6“Luminaire status”.Add / removeLuminaire searchText assignmentsDLS/TLS-AssignmentMenu 6.2:all circuitsModule8 circuit:2Circuit nameAdd / removeLuminaire searchText assignmentsDLS/TLS-Assignment Select line 1 and 2 resp. the input fieldsin line 2 with Successive selection of module and(final) circuit with All connected luminaires with addressof a device will automatic be searchand displayed. Please note that doubleaddressed lumianres in one circuit willbe identified as 1 address. If nesses-sary correct the luminaire address ofthe affected circuit.