448 OperatingMANUAL CEAG AUtoMAtiC tEst systEM At-s+ 40071860177 (C) December 2016 www.ceag.de Menu 1.1: Request in view of the of stationto be tested (M3-Mode, compare note M3) initiates a function test for theconnected final circuits:The graphic display shows the main screenwith the message “Function test”.The function of the connected luminaires isqueried and shown on the display followingthe function test lead time of 0 s to 900s, settable in the basic settings/functiontest menu.Further information can be polled in thefollowing submenus of the Test & StatusMenu (e.g. “1.2 Sum failure info” etc.).Start functiontestSum failure infoCircuit stateLuminaire stateetc. Select input field with Select installed modules or the circuitsset up under circuit setup with Finish and return to Menu 3 withLine 3: Displays the additional informa-tion, e.g. «Waiting for module data» or«FT-Current value 1,2A» Menu1.3:Line 2: Possible status displays:Circuit blockedEmergency operationNormal operationFunction test pre-runFunction testModule 2/1 circuit:1 Status displayAdd. informationCircuit nameNote M3In the Multi-Master-Mode thisoperation can be effected at anystation of the system:Device address referes to searchresults in the substation setupmenu 3 «Basic settings»this deviceall devicesDevice address 01Device nameOverview:Main menuTest & status menuBlock & reset alarmsBasic settingsDLS/TLS SetupCircuit setupLuminaire setupLogbooksetupMenu 1Start functiontestSum failure infoCircuit stateLuminaire stateDLS/TLS/3PhW stateRelay state Selection ofmenu optionswith the keys :confirm selec-tion-cel and returnto the previousmenu (anychangesentered aresaved) : canceland return tothe previousmenu (anychanges en-tered are notsaved)flashing inputprompt8.4.1 Menu 1: “Test & Status Menu” Menu 1.4: Module 2/1 circuit:1....5.....10.....15....2—-————————-Circuit name Select input field/line with Select module or circuit with Line 3 shows the current settings ofthe luminaire addresses (1 ... 20) in theselected circuit:Luminaire is off (Item 1)Luminaire is on (Item 2)Luminaire failure (Item 3)– no luminaire set up (Item 4)(see “6 Luminaire Setup”) Select a luminaire (line 2) with Line 4 shows the luminaire name(see “6.3 Text assignments”) Menu 1.2: Displays the list of fault mes-sages.Start functiontestSum failure infoCircuit stateLuminaire stateetc.Start functiontestSum failure infoCircuit stateLuminaire stateetc.Start functiontestSum failure infoCircuit stateLuminaire stateetc. Successive polling with If a number of fault messages have ac-cumulated, they can be viewed in succes-sion on the graphic display.Sum failureList: Failure 1Failure 2Failure 3etc.